Microtech Gefell M 910 Capacitor Microphone

Las exportaciones están exentas de IVA fuera de la UE o dentro de la UE para operadores intracomunitarios.
  •  
  •  
  •  
  •  
  •  

    The Microtech Gefell M910 is a hypercardioid hand-held large diaphragm condenser microphone designed primarily for live sound applications with built-in acoustic filter to reduce pop sensitivity

      Microtech Gefell M910

      The M 900 (Cardioid) large diaphragm hand-held condenser microphone was developed for instrumental and vocal soloist use in the professional market, it has a well balanced frequency response in the free-field as well as in the diffuse-field.The M 910 exhibits an ideally optimised frequency response for use by soloists. An acoustic filter sits behind the protective grill to reduce pop sensitivity. The transformerless impedance transducer, with balanced output stage delivers a high output level with low intrinsic noise.

      The membrane is a standard 1-inch gold sputtered Mylar membrane. The capsule has a ceramic backplate that is more stable to temperature changes than the often used brass ‚ the conductive side is then sputtered with chromedioxide ‚ over this is evaporated a one micron coating of Teflon. The Teflon acts as an insulator between the membrane and backplate and prevents damage as a result of incidental contact between the two.

      The M 910 can also be used as a radio microphone by using a plug-on transmitter that can supply 48V phantom power. There are quite a few of these on the market, EG: Audio Limited, Sennheiser, Shure, etc. ‚ these partner the M 900 and M 910 very well.

      Specifications

      • Polar Patterns: hypercardioid
      • Acoustical Operating Principle: Pressure gradient transducer
      • Frequency Range: 40-18000Hz
      • Sensitivty at 1kHz: 14mV/Pa
      • Switch position “reduced bass roll-off” at 90Hz: -10dB
      • Output impedance: 150 ohms
      • Noise Level: CCIR 468-4 – 22dB / DIN EN 60268-4 – 15dB-A
      • Signal-to-noise ratio: CCIR Weighted – 72dB / DIN EN 60268-4 – 79dB
      • Max. SPL for 0.5% THD: 135dB
      • Max. SPL for 0.5% THD with 10dB preattenuation: 145dB
      • Dynamic range 120dB
      • Current consumption 3mA
      • Output connector 3-pin XLR connector goldplated contacts
      • Weight: 229g
      • Dimensions (L x Ø): 218mm x 47/28mm
      • Finish: Nextel

      Mándanos un mensaje

      Cerrar