DPA Microphones 5006A d:mension™ Surround Kit
- Five carefully matched microphones
- Useful as orchestral main pair
- Peli™ Case transportation and protection
This is a complete Surround Kit with five carefully factory-matched omnidirectional microphones. Even though the standard tolerances on the 4006A Omnidirectional Microphones are extremely low, the surround match is even closer. The specially selected 4006As are matched within ±0.5 dB on both frequency response and sensitivity from mean of set.
The natural sound, high sensitivity, low noise-floor and extremely linear frequency response from 10 Hz to 20 kHz (±2 dB) of the microphones make the 4006A Omnidirectional Microphones the perfect choice for all AB Stereo, Decca Tree or surround main array recordings. The precise reproduction, total transparency and natural-sounding clarity of 4006A Omnidirectional Microphones will provide you with a lifetime of satisfying listening.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone / accessory inlays.
DPA Microphones 4006A Specifications
Directional characteristics:
Omnidirectional
Principle of operation:
Pressure
Cartridge type:
Pre-polarized condenser
Frequency range:
10 Hz to 20 kHz
Frequency range, ± 2 dB:
10 Hz to 20 kHz
Sensitivity, nominal, ±2 dB at 250 Hz:
40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted:
Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A))
Equivalent noise level, ITU-R BS.468-4:
Typ. 27 dB (max. 29 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL):
Typ. 79 dB(A)
Total Harmonic Distortion (THD):
< 1 % up to 139 dB SPL peak
Minimum load impedance:
2 kohm
Dynamic range:
Typ. 124 dB
Max. SPL, peak before clipping:
147 dB
Switchable attenuator:
0 dB / -20 dB
Output impedance:
< 200 ohm
Cable drive capability:
100 m (328 ft)
Output balance principle:
Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR):
> 60 dB
Power supply (for full specifications):
48 V Phantom power (± 4 V)
Current consumption:
2.8 mA
Connector:
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: – phase
Color:
Matte black
Weight:
163 g (5.7 oz)
Diameter:
16 to 19 mm (0.63 to 0.75 in)
Capsule diameter:
16 mm (0.63 in)
Length:
170 mm (6.7 in)
Output voltage, RMS:
> 5 V
Polarity:
+V at Pin 2 for positive sound pressure
Temperature range:
-40 °C to 50 °C (-40 °F to 122 °F)
Relative Humidity (RH):
Up to 90 %
Classification:
Conforms to IEC 61672 Class I (with Near-field Grid DD0251)
Matching tolerance:
± 0.5 dB
Phase deviation for kit:
< 5°