DPA Microphones 4015A Wide Cardioid Microphone
- Low profile – wide pickup area
- Natural reproduction
- Directional ambience pickup
- Modular flexibility
This mic is the perfect fill-in between an omnidirectional and a directional microphone.
The off-axis characteristics of this mic are totally linear, a unique quality when it comes to authentic sound reproduction. Any leakage that occurs from off-axis sound sources is still a faithful reproduction of these sounds, just softly attenuated.
Sometimes a conventional cardioid pattern just isn’t quite open enough. Recording orchestras, and other ensembles, sometimes require a compromise between blending in the room reverberation and a more precise localization. When recording instruments with complex radiation patterns, the wide cardioid (also known as hemispheric) design covers a greater sound angle and is an excellent choice. This is the ideal mic for recording grand piano, guitar, marimba and percussion, or as a spot mic for groups in a symphony orchestra. Likewise, it is an excellent speech, dubbing, or vocal mic as its enhanced richness on the bass end nicely compliments many voices.
This mic suits acoustic instruments and voices with rich and open sound. It is capable of handling extremely high sound pressure levels before clipping occurs. The 4015A Wide Cardioid Mic even includes a 20 dB pad switch in the center of the XLR connector to prevent overloading of the mic amplifier.
Specifications
- Directional pattern : Wide cardioid
- Principle of operation : Pressure gradient
- Cartridge type – Pre-polarized condenser
- Frequency response : 20 Hz – 20 kHz
- Frequency range : ±2 dB, at 60 cm (23.6 in) 40 Hz – 20 kHz
- Sensitivity, nominal, ±2 dB at 1 kHz : 10 mV/Pa; -40 dB re. 1 V/Pa
- Equivalent noise level A-weighted : Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
- Equivalent noise level : ITU-R BS.468-4 Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB setting)
- Distortion : THD < 1% 136 dB SPL RMS, 139 dB SPL peak
- Dynamic range : Typ. 121 dB
- Max. SPL : THD 10% 159 dB SPL peak
- Switchable attenuator : filters etc. 0 dB / -20 dB
- Switchable attenuator : filters etc. 0 dB / -20 dB
- Minimum load impedance : 2 kΩ
- Cable drive capability : 100 m (328 ft)
- Output balance principle : Impedance balancing with Active Drive
- Common mode rejection ratio (CMRR) : > 60 dB
- Power supply (for full performance): P48 (Phantom power)
- Current consumption : 2.8 mA
- Connector : XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: – phase
- Color : Matte black
- Weight : 158 g (5.6 oz)
- Microphone diameter : 19 mm (0.75 in)
- Capsule diameter : 19 mm (0.75 in)
- Microphone length : 170 mm (6.7 in)
- Maximum output voltage : RMS > 5 V
- Polarity : +V at pin 2 for positive sound pressure
- Temperature range : -40°C to 45°C (-40°F to 113°F)
- Relative humidity (RH) : Up to 90%
- Matching tolerance (frequency response and sensitivity) : ±1 dB
- Phase deviation for kit : < 10°
The 4015A Wide Cardioid Mic is also available as a matched stereo pair.